[2.0.x] Clear retracted status when homing the Z axis#9384
Merged
thinkyhead merged 1 commit intoMarlinFirmware:bugfix-2.0.xfrom Feb 2, 2018
Merged
[2.0.x] Clear retracted status when homing the Z axis#9384thinkyhead merged 1 commit intoMarlinFirmware:bugfix-2.0.xfrom
thinkyhead merged 1 commit intoMarlinFirmware:bugfix-2.0.xfrom
Conversation
tcm0116
force-pushed
the
2.0.x-retract
branch
from
4170798 to
ff29c7a
Compare
tcm0116
force-pushed
the
2.0.x-retract
branch
from
ff29c7a to
7035471
Compare
This was referenced Aug 21, 2018
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
2 participants
Add this suggestion to a batch that can be applied as a single commit.This suggestion is invalid because no changes were made to the code.Suggestions cannot be applied while the pull request is closed.Suggestions cannot be applied while viewing a subset of changes.Only one suggestion per line can be applied in a batch.Add this suggestion to a batch that can be applied as a single commit.Applying suggestions on deleted lines is not supported.You must change the existing code in this line in order to create a valid suggestion.Outdated suggestions cannot be applied.This suggestion has been applied or marked resolved.Suggestions cannot be applied from pending reviews.Suggestions cannot be applied on multi-line comments.Suggestions cannot be applied while the pull request is queued to merge.Suggestion cannot be applied right now. Please check back later.
Slic3r likes to issue a
G10at the end of a print with no correspondingG11. I had noticed this, and decided to add aG11to my start G-code to ensure that the first retract on the next print wasn't missed. However, I realized that the sequenceG10,G28,G11will cause the nozzle to be lowered by the hop amount after theG28. This is bad because now the nozzle is actually lower than expected and will likely cause it to crash into the bed. This PR addresses both issues by clearing theretractedstatus of all of the extruders when the Z axis is homed.