-
Notifications
You must be signed in to change notification settings - Fork 0
Home
Edern Ollivier edited this page Jan 28, 2022
·
3 revisions
Welcome to the ProjectArduinoDue wiki!
The gyrometer is the CRS03-1T from Silicon Sensing for the heading angle.
The inclinations sensor is the BNO055 from Adafruit for the inclinations angles.
The motors are supplied by the motor shield and the Arduino Due board from Arduino.
The PC of control is the HP PC computer to compile and run the project on the Arduino IDE.
The motors are the MOT-GEARM-50:1-CPR64 from MC Hobby.
The couplings are the POL-AXEHUB-6mm-2 from MC Hobby.
The mockup was made with the Makerbeam kit from MC Hobby.
The microcontroller is the Atmel SAM3X8E from Arduino.