x86, 8042: Enable A20 using KBC to fix S3 resume on some MSI laptops

Some MSI laptop BIOSes are broken - INT 15h code uses port 92h to enable A20
line but resume code assumes that KBC was used.
The laptop will not resume from S3 otherwise but powers off after a while
and then powers on again stuck with a blank screen.

Fix it by enabling A20 using KBC in i8042_platform_init for x86.

Fixes https://bugzilla.kernel.org/show_bug.cgi?id=12878

Signed-off-by: Ondrej Zary <[email protected]>
Cc: Dmitry Torokhov <[email protected]>
Cc: Alan Cox <[email protected]>
Cc: Rafael J. Wysocki <[email protected]>
Cc: <[email protected]>
Link: http://lkml.kernel.org/r/[email protected]
Signed-off-by: H. Peter Anvin <[email protected]>

drivers/input/serio/i8042-x86ia64io.h

@@ -921,6 +921,7 @@ static int __init i8042_platform_init(void)
 	int retval;
 
 #ifdef CONFIG_X86
+	u8 a20_on = 0xdf;
 	/* Just return if pre-detection shows no i8042 controller exist */
 	if (!x86_platform.i8042_detect())
 		return -ENODEV;
@@ -960,6 +961,14 @@ static int __init i8042_platform_init(void)
 
 	if (dmi_check_system(i8042_dmi_dritek_table))
 		i8042_dritek = true;
+
+	/*
+	 * A20 was already enabled during early kernel init. But some buggy
+	 * BIOSes (in MSI Laptops) require A20 to be enabled using 8042 to
+	 * resume from S3. So we do it here and hope that nothing breaks.
+	 */
+	i8042_command(&a20_on, 0x10d1);
+	i8042_command(NULL, 0x00ff);	/* Null command for SMM firmware */
 #endif /* CONFIG_X86 */
 
 	return retval;