drm/bridge_connector: enable HPD by default if supported

Hotplug events reported by bridge drivers over drm_bridge_hpd_notify()
get ignored unless somebody calls drm_bridge_hpd_enable(). When the
connector for the bridge is bridge_connector, such a call is done from
drm_bridge_connector_enable_hpd().

However drm_bridge_connector_enable_hpd() is never called on init paths,
documentation suggests that it is intended for suspend/resume paths.

In result, once encoders are switched to bridge_connector,
bridge-detected HPD stops working.

This patch adds a call to that API on init path.

This fixes HDMI HPD with rcar-du + adv7513 case when adv7513 reports HPD
events via interrupts.

Fixes: c24110a ("drm: rcar-du: Use drm_bridge_connector_init() helper")
Signed-off-by: Nikita Yushchenko <[email protected]>
Signed-off-by: Paul Cercueil <[email protected]>
Tested-by: Kieran Bingham <[email protected]>
Reviewed-by: Kieran Bingham <[email protected]>
Reviewed-by: Laurent Pinchart <[email protected]>
Link: https://patchwork.freedesktop.org/patch/msgid/[email protected]

drivers/gpu/drm/drm_bridge_connector.c

@@ -384,8 +384,10 @@ struct drm_connector *drm_bridge_connector_init(struct drm_device *drm,
 				    connector_type, ddc);
 	drm_connector_helper_add(connector, &drm_bridge_connector_helper_funcs);
 
-	if (bridge_connector->bridge_hpd)
+	if (bridge_connector->bridge_hpd) {
 		connector->polled = DRM_CONNECTOR_POLL_HPD;
+		drm_bridge_connector_enable_hpd(connector);
+	}
 	else if (bridge_connector->bridge_detect)
 		connector->polled = DRM_CONNECTOR_POLL_CONNECT
 				  | DRM_CONNECTOR_POLL_DISCONNECT;