You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have a ESP32 MH ET Live ESP32 DEVKIT board emulating 6 devices for a 6 socket board, using fauxmo. I have the latest version of fauxmo 3.4.0 and am using Arduino 1.8.19 and ESP32 V1.06 installed.
Alexa added all 6 devices and switches them on and off for approx 6 hrs to 8 hrs
After that Alexa says the device is not responding. I know the ESP 32 has not stuck in some loop as all other fuctions like using a touch pin to switch on the relay works fine.
However typically after 6 to 8 hrs alexa fails to find the device. All I need to do is to reset the device and Alexa finds it immediately (So it is a device end problem and not a alexa problem)
Any suggestions ?
Full Code attached
P.S.
If you are wondering about this piece of code :
if(flgFauxmoActivated) {
if ((millis() - tm_fauxmorestart) > 900000) { // every 15 mins stop and restart fauxmo. Being tried because fauxmo disconnects every few hours
fauxmo.enable(false);
tm_fauxmorestart = millis() ;
delay(100);
fauxmo.enable(true);
}
fauxmo.handle();
}
It was an attempt to work around the problem by trying to disable fauxmo and restart fauxmo every few minutes , hoping it would clear some buffers etc. Seemed to make it go for longer but definitely fails within 12 hrs
I have a ESP32 MH ET Live ESP32 DEVKIT board emulating 6 devices for a 6 socket board, using fauxmo. I have the latest version of fauxmo 3.4.0 and am using Arduino 1.8.19 and ESP32 V1.06 installed.
Alexa added all 6 devices and switches them on and off for approx 6 hrs to 8 hrs
After that Alexa says the device is not responding. I know the ESP 32 has not stuck in some loop as all other fuctions like using a touch pin to switch on the relay works fine.
However typically after 6 to 8 hrs alexa fails to find the device. All I need to do is to reset the device and Alexa finds it immediately (So it is a device end problem and not a alexa problem)
Any suggestions ?
Full Code attached
P.S.
If you are wondering about this piece of code :
if(flgFauxmoActivated) {
if ((millis() - tm_fauxmorestart) > 900000) { // every 15 mins stop and restart fauxmo. Being tried because fauxmo disconnects every few hours
fauxmo.enable(false);
tm_fauxmorestart = millis() ;
delay(100);
fauxmo.enable(true);
}
fauxmo.handle();
}
It was an attempt to work around the problem by trying to disable fauxmo and restart fauxmo every few minutes , hoping it would clear some buffers etc. Seemed to make it go for longer but definitely fails within 12 hrs
Alexa SpikeGuardV3.txt
The text was updated successfully, but these errors were encountered: