[202205][Mellanox]Check dmi file permission before access #11346
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Signed-off-by: Sudharsan Dhamal Gopalarathnam [email protected]
Cherry-pick of #11309
Why I did it
During the system boot up when 'show platform status' or 'show version' command is executed before STATE_DB CHASSIS_INFO table is populated, the show will try to fallback to use the platform API. The DMI file in mellanox platforms require root permission for access. So if the show commands are executed as admin or any other user, the following error log will appear in the syslog
Jun 28 17:21:25.612123 sonic ERR show: Fail to decode DMI /sys/firmware/dmi/entries/2-0/raw due to PermissionError(13, 'Permission denied')
How I did it
Check the file permission before accessing it.
How to verify it
Added UT to verify. Manually verified if the error log is not thrown.
Why I did it
How I did it
How to verify it
Which release branch to backport (provide reason below if selected)
Description for the changelog
Link to config_db schema for YANG module changes
A picture of a cute animal (not mandatory but encouraged)