PCI: Add boot interrupt quirk mechanism for Xeon chipsets

The following was observed by Kar Hin Ong with RT patchset:

  Backtrace:
  irq 19: nobody cared (try booting with the "irqpoll" option)
  CPU: 0 PID: 3329 Comm: irq/34-nipalk Tainted:4.14.87-rt49 #1
  Hardware name: National Instruments NI PXIe-8880/NI PXIe-8880,
           BIOS 2.1.5f1 01/09/2020
  Call Trace:
  <IRQ>
    ? dump_stack+0x46/0x5e
    ? __report_bad_irq+0x2e/0xb0
    ? note_interrupt+0x242/0x290
    ? nNIKAL100_memoryRead16+0x8/0x10 [nikal]
    ? handle_irq_event_percpu+0x55/0x70
    ? handle_irq_event+0x4f/0x80
    ? handle_fasteoi_irq+0x81/0x180
    ? handle_irq+0x1c/0x30
    ? do_IRQ+0x41/0xd0
    ? common_interrupt+0x84/0x84
  </IRQ>
  ...
  handlers:
  [<ffffffffb3297200>] irq_default_primary_handler threaded
  [<ffffffffb3669180>] usb_hcd_irq
  Disabling IRQ #19

The problem being that this device is triggering boot interrupts
due to threaded interrupt handling and masking of the IO-APIC. These
boot interrupts are then forwarded on to the legacy PCH's PIRQ lines
where there is no handler present for the device.

Whenever a PCI device fires interrupt (INTx) to Pin 20 of IOAPIC 2
(GSI 44), the kernel receives two interrupts:

   1. Interrupt from Pin 20 of IOAPIC 2  -> Expected
   2. Interrupt from Pin 19 of IOAPIC 1  -> UNEXPECTED

Quirks for disabling boot interrupts (preferred) or rerouting the
handler exist but do not address these Xeon chipsets' mechanism:
https://lore.kernel.org/lkml/[email protected]/

Add a new mechanism via PCI CFG for those chipsets supporting CIPINTRC
register's dis_intx_rout2ich bit.

Link: https://lore.kernel.org/r/[email protected]
Reported-by: Kar Hin Ong <[email protected]>
Tested-by: Kar Hin Ong <[email protected]>
Signed-off-by: Sean V Kelley <[email protected]>
Signed-off-by: Bjorn Helgaas <[email protected]>
Reviewed-by: Thomas Gleixner <[email protected]>
Cc: [email protected]

drivers/pci/quirks.c

@@ -1970,26 +1970,92 @@ DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	PCI_DEVICE_ID_INTEL_80332_1,	quirk
 /*
  * IO-APIC1 on 6300ESB generates boot interrupts, see Intel order no
  * 300641-004US, section 5.7.3.
+ *
+ * Core IO on Xeon E5 1600/2600/4600, see Intel order no 326509-003.
+ * Core IO on Xeon E5 v2, see Intel order no 329188-003.
+ * Core IO on Xeon E7 v2, see Intel order no 329595-002.
+ * Core IO on Xeon E5 v3, see Intel order no 330784-003.
+ * Core IO on Xeon E7 v3, see Intel order no 332315-001US.
+ * Core IO on Xeon E5 v4, see Intel order no 333810-002US.
+ * Core IO on Xeon E7 v4, see Intel order no 332315-001US.
+ * Core IO on Xeon D-1500, see Intel order no 332051-001.
+ * Core IO on Xeon Scalable, see Intel order no 610950.
  */
-#define INTEL_6300_IOAPIC_ABAR		0x40
+#define INTEL_6300_IOAPIC_ABAR		0x40	/* Bus 0, Dev 29, Func 5 */
 #define INTEL_6300_DISABLE_BOOT_IRQ	(1<<14)
 
+#define INTEL_CIPINTRC_CFG_OFFSET	0x14C	/* Bus 0, Dev 5, Func 0 */
+#define INTEL_CIPINTRC_DIS_INTX_ICH	(1<<25)
+
 static void quirk_disable_intel_boot_interrupt(struct pci_dev *dev)
 {
 	u16 pci_config_word;
+	u32 pci_config_dword;
 
 	if (noioapicquirk)
 		return;
 
-	pci_read_config_word(dev, INTEL_6300_IOAPIC_ABAR, &pci_config_word);
-	pci_config_word |= INTEL_6300_DISABLE_BOOT_IRQ;
-	pci_write_config_word(dev, INTEL_6300_IOAPIC_ABAR, pci_config_word);
-
+	switch (dev->device) {
+	case PCI_DEVICE_ID_INTEL_ESB_10:
+		pci_read_config_word(dev, INTEL_6300_IOAPIC_ABAR,
+				     &pci_config_word);
+		pci_config_word |= INTEL_6300_DISABLE_BOOT_IRQ;
+		pci_write_config_word(dev, INTEL_6300_IOAPIC_ABAR,
+				      pci_config_word);
+		break;
+	case 0x3c28:	/* Xeon E5 1600/2600/4600	*/
+	case 0x0e28:	/* Xeon E5/E7 V2		*/
+	case 0x2f28:	/* Xeon E5/E7 V3,V4		*/
+	case 0x6f28:	/* Xeon D-1500			*/
+	case 0x2034:	/* Xeon Scalable Family		*/
+		pci_read_config_dword(dev, INTEL_CIPINTRC_CFG_OFFSET,
+				      &pci_config_dword);
+		pci_config_dword |= INTEL_CIPINTRC_DIS_INTX_ICH;
+		pci_write_config_dword(dev, INTEL_CIPINTRC_CFG_OFFSET,
+				       pci_config_dword);
+		break;
+	default:
+		return;
+	}
 	pci_info(dev, "disabled boot interrupts on device [%04x:%04x]\n",
 		 dev->vendor, dev->device);
 }
-DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,   PCI_DEVICE_ID_INTEL_ESB_10,	quirk_disable_intel_boot_interrupt);
-DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,   PCI_DEVICE_ID_INTEL_ESB_10,	quirk_disable_intel_boot_interrupt);
+/*
+ * Device 29 Func 5 Device IDs of IO-APIC
+ * containing ABAR—APIC1 Alternate Base Address Register
+ */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	PCI_DEVICE_ID_INTEL_ESB_10,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	PCI_DEVICE_ID_INTEL_ESB_10,
+		quirk_disable_intel_boot_interrupt);
+
+/*
+ * Device 5 Func 0 Device IDs of Core IO modules/hubs
+ * containing Coherent Interface Protocol Interrupt Control
+ *
+ * Device IDs obtained from volume 2 datasheets of commented
+ * families above.
+ */
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	0x3c28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	0x0e28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	0x2f28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	0x6f28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_FINAL(PCI_VENDOR_ID_INTEL,	0x2034,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	0x3c28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	0x0e28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	0x2f28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	0x6f28,
+		quirk_disable_intel_boot_interrupt);
+DECLARE_PCI_FIXUP_RESUME(PCI_VENDOR_ID_INTEL,	0x2034,
+		quirk_disable_intel_boot_interrupt);
 
 /* Disable boot interrupts on HT-1000 */
 #define BC_HT1000_FEATURE_REG		0x64