HackRF One r10

[mossmann]

HackRF One r10 is based on r8, reverting most of the changes made in r9.

Major differences between r8 and r10:

• add reverse current protection diode to antenna port power supply
• change PCB stack-up
• update design to KiCad 6

[catalinalb]

Hi, could you replace the micro usb connector with USB C?

I just fried my original hacrkf board last night, The NXP Chip was getting to 108 degrees C.
So I measured around and on VDD I was getting only 2.5v instead of 3.3.
Connected a 18650 cell there while tring to communicate over usb cable (with 5v removed from the usb cable) but no success.
No I get only one LED that lights dim and the chip is still getting to 100 degrees :(

Thank you,
Catalin Alb

[mossmann]

Hi, could you replace the micro usb connector with USB C?

I just fried my original hacrkf board last night, The NXP Chip was getting to 108 degrees C. So I measured around and on VDD I was getting only 2.5v instead of 3.3. Connected a 18650 cell there while tring to communicate over usb cable (with 5v removed from the usb cable) but no success. No I get only one LED that lights dim and the chip is still getting to 100 degrees :(

Thank you, Catalin Alb

HackRF One r10 is already in production. Further modifications to the design will not be made. If you need technical support, please open a separate issue or join the #hackrf channel on the Great Scott Gadgets Discord server.