No support for Olimex PICO2-XL(2MB)/XXL(16MB)

[hlide]

As the title says, I cannot see any reference to PICO2-XXL when trying to select board in Arduino Arduino IDE 2.x.x using version 4.4.4.

[earlephilhower]

Since you seem to have one or both in hand, why not try a stab at making a new board definition?

OTW, you can use the Generic RP2350 and adjust your flash and PSRAM config as appropriate.

[hlide]

I wish but I'm not familiar at all with the board definition. I'll try the generic one. De: "Earle F. Philhower, III" ***@***.***> À: "earlephilhower/arduino-pico" ***@***.***> Cc: "hlide" ***@***.***>, "Author" ***@***.***> Envoyé: Dimanche 23 Février 2025 20:26:15 Objet: Re: [earlephilhower/arduino-pico] No support for Olimex PICO2-XL(2MB)/XXL(16MB) (Issue #2820) Since you seem to have one or both in hand, why not try a stab at [ https://github.com/earlephilhower/arduino-pico/blob/master/docs/contrib.rst#adding-a-new-board | making a new board definition ] ? OTW, you can use the Generic RP2350 and adjust your flash and PSRAM config as appropriate. — Reply to this email directly, [ #2820 (comment) | view it on GitHub ] , or [ https://github.com/notifications/unsubscribe-auth/AAAN3UMB2XEDL72AUOUUAS32RIOFPAVCNFSM6AAAAABXWS4JEOVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDMNZXGA3TEOBXGA | unsubscribe ] . You are receiving this because you authored the thread. Message ID: ***@***.***> earlephilhower left a comment [ #2820 (comment) | (earlephilhower/arduino-pico#2820) ] Since you seem to have one or both in hand, why not try a stab at [ https://github.com/earlephilhower/arduino-pico/blob/master/docs/contrib.rst#adding-a-new-board | making a new board definition ] ? OTW, you can use the Generic RP2350 and adjust your flash and PSRAM config as appropriate. — Reply to this email directly, [ #2820 (comment) | view it on GitHub ] , or [ https://github.com/notifications/unsubscribe-auth/AAAN3UMB2XEDL72AUOUUAS32RIOFPAVCNFSM6AAAAABXWS4JEOVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDMNZXGA3TEOBXGA | unsubscribe ] . You are receiving this because you authored the thread. Message ID: ***@***.***>

[hlide]

Ok I aswered to your mail, so I didn't see there is a link under making a new board definition

I will try it too.