You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Oct 14, 2018. It is now read-only.
Replace the ESTOP 2 pin header with a locking connector like P901, P902 and P105.
I wouldn't want the ESTOP connector falling off during a job!
Note: I've populated mine with one already, but it sticks over the side <1mm. May require moving the connector slightly away from the edge of the board (room seems available).
The text was updated successfully, but these errors were encountered:
#3 replace C301, C302, C303 and C501 with ceramic 0805;
#4 change endstop connectors to 6x1 and 6x2 to allow key position
#9 change E-STOP connector to KK type;
#18 add 10k pulldowns on heater outputs from CPU
#19 change E-STOP buffers to HCT type to always drive FETs at 5V and remove inverting drivers on heater outputs;
#20 add 24LC256 I2C EEPROM
Replace the ESTOP 2 pin header with a locking connector like P901, P902 and P105.
I wouldn't want the ESTOP connector falling off during a job!
Note: I've populated mine with one already, but it sticks over the side <1mm. May require moving the connector slightly away from the edge of the board (room seems available).
The text was updated successfully, but these errors were encountered: