Why2025 Firmware for ESP32-C6

This repository contains the firmware for the Why2025 project running on the ESP32-C6.

Quick Start

1. Prepare the environment

   make prepare

   This step prepares the environment for the build process. It only needs to be done once, though it can be repeated if necessary.

2. Build, flash, and monitor

   make build flash monitor

   This command will build the software, flash it onto the device, and start monitoring the device. Use this command for the main operations.

3. Specify the port

   make build flash monitor PORT=/dev/ttyACM1

   If you need to specify a different port, use this command. Replace /dev/ttyACM1 with the appropriate port for your device.

   Exiting the monitor works the same as with Telnet, 'CTRL + ]' followed by 'quit <enter>'.

Notes

• The make prepare command is time-consuming and typically only needs to be run once unless there are changes that require re-preparation.
• Use the port specification command if you need to communicate with a device on a specific port.

Troubleshooting

If you encounter any issues, ensure that the port specified matches the port your device is connected to and that all necessary preparations have been completed.