Skip to content

Voron Trident
Compare
Choose a tag to compare
@FHeilmann FHeilmann released this 31 Aug 15:00
· 37 commits to main since this release
Trident
f669998

Release Notes

This marks the full release of the Voron Trident 3D printer.

If you're just getting started with your Voron Trident build, the files attached to this release contain the most up-to-date parts required for your Voron 3D printer build. If you are currently building, or have already built your Voron Trident, please check the list of fixes and updates below and determine whether you need to update your printer accordingly.

Since the pre-release, the following changes have been made:

  • 8326994: Fixed CAD filename
  • 0df5d06, 4369164: Manual Updates and Fixes
  • 5cfb431: Updates hex nut positions to improve M5 thread engagement on z-carriages
  • ab21663: Fix mini12854 display knob for better engagement when pressed
  • 3ac73d4, a258ac6: Update CAD to reflect changes of other commits
  • 017df26, f8f42b7: Fix Z-tilt coordinates in sample config
  • bf77e86: Updated blower housing for AB, improving wiring clearance, add panasonic probe holder
  • f669998: Remove redundant sections from sample config

Voron Trident Pre-Release Notes

Welcome Voron Trident, the evolution of the Voron 1 platform. While nearly every component has changed, an easy upgrade path was retained for current Voron 1.8 owners. The files attached to this release are the most up-to-date parts required to build your Voron 3D printer. Please see the list below for changes from Voron 1.8.

  • Gantry
    • AB Stepper Mounts
      • Revised geometry to help prevent improper belt routing.
      • New wiring path with cover that does not capture the gantry wiring harness.
      • Optional A stepper mounted Y endstop switch.
    • XY Axis
      • Adopted the Voron 2.4 XY Axis layout with bottom mounted linear rails. This includes the ability to utilize the V2.4 style endstop pod (microswitch or hall effect)
      • Integrated the community developed MGN12 X axis setup.
      • Updated cable chain routing to match the V2.4 setup
  • Z Axis
    • Completely new three stepper configuration.
      • Utilizes MGN9H linear rails instead of linear rods.
    • Utilizes GE5C spherical bearings at each joint
    • Integrated Cable chain wire management
    • Uses the V2.4 Z endstop switch assembly
    • Retains compatibility with the V1.8 build plate
    • Increased max Z travel to 250mm
  • Skirts and Electronics Compartment:
    • Reconfigured all electronics to be located below the deck.
    • Shares dimensions and screen and side fan compatibility with Voron 2.4
    • New power supply and electronic mounts
    • New front Mini12864 display mount.
    • New recommended feet but retains compatibility with the compressor feet.
  • Panels and Exhaust:
    • Slightly modified exhaust housing utilizing two screws to better hold the filter cover.
    • Updated panel clips to support the recommended use of 3mm foam tape on the side panels and 1mm foam tape on the top and rear panels.
    • Requires new panels for all but the top panel.
  • Miscellaneous
    • Added support for 350mm build plates
    • V1.8 frame upgrade possible with minimal modifications. See frame upgrade manual.

Special thanks to all the contributors

Thank you to everyone who contributed to this update and reported issues with the pre-release.

More information

Assets 2
Loading