-
I think I'm having trouble with the laser (calibration?) again. I ran a sample yesterday and got the 'invalid laser calib' warning, and then blank levels of gas. I was doing fine with fusions but this is a step heat. log file and screenshot attached. any suggestions? I'm trying to run at 0.8W. laser calib file: [PowerOutput] |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
given those coefficients for power calibration the minimum requested power is 0.9313.
where |
Beta Was this translation helpful? Give feedback.
given those coefficients for power calibration the minimum requested power is 0.9313.
where
x
is % laser output. If you request 0.8W then there is no value between 0-100 that satisfies the calibration equation.