This repository holds all the STL files used by the sorter
All parts are printed in PLA except the following ones:
For these parts you should use a more resistant material such as PETG or ASA, since they will be in close contact with the motors and their heat would deform the plastic part:
- Z STRESS RELIEF.stl
- ARM Z LARGE.stl
Camera parts should be printed using PETG, since over time they could sag.
None of the parts require supports, brim or raft. Depending on your 3D printer, however, you might want to add some brim to the smaller parts, to increase adhesion to the build plate.
Some parts are designed with an hole that is slightly smaller than the required one, since it would be impossible to achieve the perfect diameter while printing.
You'll have to re-drill the hole of the following parts:
- SEPARATOR DYNAMIC.stl (12 mm)