Add Go links to cache to enable faster validation

[weshaggard]

This changed depends on the fix in #1580 to fully enable caching of the MD file links in the go repo.

This PR also increases the timeout of the pipeline because we have been very close to the default 60 mins for a while and this new caching will likely push it over the limit.

[check-enforcer-staging]

This pull request is protected by Check Enforcer.

What is Check Enforcer?

Check Enforcer helps ensure all pull requests are covered by at least one check-run (typically an Azure Pipeline). When all check-runs associated with this pull request pass then Check Enforcer itself will pass.

Why am I getting this message?

You are getting this message because Check Enforcer did not detect any check-runs being associated with this pull request within five minutes. This may indicate that your pull request is not covered by any pipelines and so Check Enforcer is correctly blocking the pull request being merged.

What should I do now?

If the check-enforcer check-run is not passing and all other check-runs associated with this PR are passing (excluding license-cla) then you could try telling Check Enforcer to evaluate your pull request again. You can do this by adding a comment to this pull request as follows:
/check-enforcer evaluate
Typically evaulation only takes a few seconds. If you know that your pull request is not covered by a pipeline and this is expected you can override Check Enforcer using the following command:
/check-enforcer override
Note that using the override command triggers alerts so that follow-up investigations can occur (PRs still need to be approved as normal).