[MetricsAdvisor] Updated DataFeedSource constructors

[kinelski]

Adding/removing data source constructors based on what parameters are currently required by the service (fixes #21616).

[kinelski]

Not actually supported by the service. Other properties are required now. We'll possibly add this constructor back again as new types of credentials are added.

[check-enforcer]

This pull request is protected by Check Enforcer.

What is Check Enforcer?

Check Enforcer helps ensure all pull requests are covered by at least one check-run (typically an Azure Pipeline). When all check-runs associated with this pull request pass then Check Enforcer itself will pass.

Why am I getting this message?

You are getting this message because Check Enforcer did not detect any check-runs being associated with this pull request within five minutes. This may indicate that your pull request is not covered by any pipelines and so Check Enforcer is correctly blocking the pull request being merged.

What should I do now?

If the check-enforcer check-run is not passing and all other check-runs associated with this PR are passing (excluding license-cla) then you could try telling Check Enforcer to evaluate your pull request again. You can do this by adding a comment to this pull request as follows:
/check-enforcer evaluate
Typically evaulation only takes a few seconds. If you know that your pull request is not covered by a pipeline and this is expected you can override Check Enforcer using the following command:
/check-enforcer override
Note that using the override command triggers alerts so that follow-up investigations can occur (PRs still need to be approved as normal).

What if I am onboarding a new service?

Often, new services do not have validation pipelines associated with them. In order to bootstrap pipelines for a new service, please perform following steps:

For data-plane/track 2 SDKs Issue the following command as a pull request comment:

/azp run prepare-pipelines
This will run a pipeline that analyzes the source tree and creates the pipelines necessary to build and validate your pull request. Once the pipeline has been created you can trigger the pipeline using the following comment:
/azp run net - [service] - ci

For track 1 management-plane SDKs

Please open a separate PR and to your service SDK path in this file. Once that PR has been merged, you can re-run the pipeline to trigger the verification.

[maririos]

do u want to add a test for it? I think as is fine, but just in case u want to check query empty and the exception and etc...

[kinelski]

Added tests for new ctors.