Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

Clarification on profiling after clamp #74

Open
ossnorry opened this issue Aug 27, 2023 · 2 comments
Open

Clarification on profiling after clamp #74

ossnorry opened this issue Aug 27, 2023 · 2 comments

Comments

@ossnorry
Copy link

I just had a quick question, so if I do a calibration and clamp, if I were to run a profiling afterward I would just set it all to “as measured” and the following ICC should properly correct non-linear parts?
@ledoge
Copy link
Owner

ledoge commented Aug 28, 2023

yes

@ossnorry
Copy link
Author

ossnorry commented Sep 8, 2023 •
edited
Loading

Should I be "using linear calibration instead" or "embed calibration curves in profile" when doing a profile only run?

Screenshot 2023-09-08 141956

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
2 participants
@ledoge @ossnorry