Flash not operational during reference image creation

[SGXander]

The Problem

after alignment step 1, step 2 appears to disable the flash and use the rear LED on the board. This behaviour continues until the ESP is reset, where it works for alignment again but then breaks on step 2 repeatably

Version

16.0.0-RC4

Logfile

not at stage where menu available

Expected Behavior

clicking create new reference button should produce the same image as alignment

Screenshots

Additional Context

the ESP must be reset to restore flash functionality during alignment but the issue is repeatable

[mesistostefre]

Confirmed. Looks like the flash works just once and is disabled til next reset. Found no workaround. I'll roll back ...

[caco3]

Might be the same issue as on #3338

[gotaede]

I can reproduce the error with firmware v15.7.0 and webinterface 16.0.0-RC4