lower_z_umbilical seems to have side mount hole offset from correct 2020 mounting position

[Altirix]

printed and installed, was unable to get the side hole screwed in, tried multiple times. ended up shining a light and noticed it was partially blocked by the extrusion itself.

checking the cad also showed the hole is 6mm from the top and 10.5mm from the bottom.

my assumption is the hole was indexed on the outer face, which puts the hole in the center of that face, however that face includes ~4mm from the material that goes ontop of the extrusion.

its atleast more than strong with just the two top mounted screws

https://github.com/hartk1213/MISC/blob/main/Voron%20Mods/Voron%202-Trident/2.4/Voron2.4_Z_Umbilical/STLs/lower_z_umbilical.stl