esp32-c3 (LILYGO T-01C3 aka esp01 with esp32c3) boot issue after update with UART in config #3924
Description
The problem
This is serial log as the device does not become available on wifi
Log after flashing on x64 system
it does boot and show as connect, but no webserver is up etc. (And yes, webserver is specified in the config)
Which version of ESPHome has the issue?
2022.12.0 and also tried 2023.01.0.dev0
What type of installation are you using?
Home Assistant Add-on
Which version of Home Assistant has the issue?
2022.12.5
What platform are you using?
ESP32
Board
esp01-c3
Component causing the issue
bluetooth_proxy?
Example YAML snippet
No response
Anything in the logs that might be useful for us?
Primary usage for the device is obis reading using
external_components:
- source: github://evlo/esphome_ZPA-ZE312
components: [obis]
refresh: 0s
Additional information
I thought it might be related to bluetooth_proxy since I updated and enabled bt proxy at the same time, but even after removing bluetooth_proxy from config, it still does not boot properly.
Also pre 2022.12 I needed to build using
esp32:
board: esp32-c3-devkitm-1
framework:
type: arduino
version: 2.0.3
platform_version: 4.4.0
on arm64 (ha yellow)
but on x64 it was ok
with 2022.12 it builds with
esp32:
board: esp32-c3-devkitm-1
framework:
type: arduino
both on arm64 and x64, but resulting firmware does not boot for the checksum issue in the screenshot
With 2022.12.0 AND
board: esp32-c3-devkitm-1
framework:
type: arduino
version: 2.0.3
platform_version: 4.4.0
results is this thing
This only happens if UART component is in yaml config