HID: i2c-hid: Use address probe to wake on resume

Certain devices, both from STM and Weida Tech, need to be woken up after
having entered a deeper sleep state. The relevant places to wake up such
device is during our initial HID probe, and after resuming.

A retry for power commands was previously added to i2c_hid_set_power to
wake up Weida Tech devices, but lacked sufficient sleep for STM devices.
Replace the power command retry with the same address probe we using
during our initial HID probe.

Signed-off-by: Kenny Levinsen <[email protected]>
Signed-off-by: Jiri Kosina <[email protected]>

Author: kennylevinsen

drivers/hid/i2c-hid/i2c-hid-core.c

@@ -408,19 +408,6 @@ static int i2c_hid_set_power(struct i2c_hid *ihid, int power_state)
 
 	i2c_hid_dbg(ihid, "%s\n", __func__);
 
-	/*
-	 * Some devices require to send a command to wakeup before power on.
-	 * The call will get a return value (EREMOTEIO) but device will be
-	 * triggered and activated. After that, it goes like a normal device.
-	 */
-	if (power_state == I2C_HID_PWR_ON) {
-		ret = i2c_hid_set_power_command(ihid, I2C_HID_PWR_ON);
-
-		/* Device was already activated */
-		if (!ret)
-			goto set_pwr_exit;
-	}
-
 	ret = i2c_hid_set_power_command(ihid, power_state);
 	if (ret)
 		dev_err(&ihid->client->dev,
@@ -999,6 +986,14 @@ static int i2c_hid_core_resume(struct i2c_hid *ihid)
 
 	enable_irq(client->irq);
 
+	/* Make sure the device is awake on the bus */
+	ret = i2c_hid_probe_address(ihid);
+	if (ret < 0) {
+		dev_err(&client->dev, "nothing at address after resume: %d\n",
+			ret);
+		return -ENXIO;
+	}
+
 	/* Instead of resetting device, simply powers the device on. This
 	 * solves "incomplete reports" on Raydium devices 2386:3118 and
 	 * 2386:4B33 and fixes various SIS touchscreens no longer sending