You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hi, my setup is standar ender 3 with skr e3 dip + tmc2130 firmware from this github marlin 2.0.7 . Why my hotend slow down when reaching 170°C to 220° need time more than 3 minutes?
my other ender 3 skr e3 dip + tmc2208 only need 2 minutes 5 second.
I already try replace psu, hotend heater, thermistor but facing same problems..
Or this new bug? Thermistor type at marlin is no 1.
Pid tuning already done too.. but same problems
The text was updated successfully, but these errors were encountered:
Hi, my setup is standar ender 3 with skr e3 dip + tmc2130 firmware from this github marlin 2.0.7 . Why my hotend slow down when reaching 170°C to 220° need time more than 3 minutes?
my other ender 3 skr e3 dip + tmc2208 only need 2 minutes 5 second.
I already try replace psu, hotend heater, thermistor but facing same problems..
Or this new bug? Thermistor type at marlin is no 1.
Pid tuning already done too.. but same problems
The text was updated successfully, but these errors were encountered: