Can't use Trim Anymore!

[Username778]

Encoding error:
Encoding Failed. Log has been printed to progress windows.

What happen to my A.motion? Last week i can use it, then this week i got this problem that nobody know how to solve it?
Unistall and Install Aegisub, Reopen Aegisub, Install A.mo again, all of that didn't work a bit.

[CoffeeFlux]

Do you have the log? Hard to diagnose with no info.

[Subarashii-no-Fansub]

maybe I have same problem, here is my logs:

Encoding error:
raw [error]: raw input requires a resolution.
x264 [error]: could not open input file `file (720).mkv' via any method!
mp4 [error]: failed to finish movie.
If there is no log before this, your encoder is not a working executable or your encoding command is invalid.

[petzku]

I got the same error as @Subarashii-no-Fansub earlier today. Using the ffmpeg preset instead works normally.

a-mo version 1.0.9, x264:

x264 0.160.3011 cde9a93
built on Aug  4 2020, gcc: 10.1.0
x264 configuration: --chroma-format=all
libx264 configuration: --chroma-format=all
x264 license: GPL version 2 or later

[swiftarm]

I'm not even getting an error message. Using x264, I just get the cmd.exe pop up, and it sits there, does nothing
cmd.

If I close it, I get this error, with no actual output.
encoding failed

And it just outputs a 0 byte file.

Completely new install of Aegis r8903+1 with Dependency Control, and Aegisub-motion 1.0.9. I've tested running x264 by itself and was able to encode 5 frames of a video without any issues.

Edit: Well.. now I can't even run x264 by itself anymore. Just doesn't do anything. I give up, I'm cursed.

Edit2: Ok, trim works, but it runs unbelievably slow for some god forsaken reason.

[Subarashii-no-Fansub]

Finally I have a x264 without trim? or something else that it does not support.

using another x264 build fix my problem