diff --git a/config/zooz/zen22v2.xml b/config/zooz/zen22v2.xml index 70170f17ac..3c20a0163b 100644 --- a/config/zooz/zen22v2.xml +++ b/config/zooz/zen22v2.xml @@ -1,26 +1,114 @@ - + - + Controls the on/off orientation of the rocker switch - - + + + - - Choose if you want the LED indicator to turn on when switch is on or off + + + Control the LED indicator on switch + + - - Enable or disable LED indicator so it stays off at all times - - + + Use this parameter to enable or disable the auto turn-off timer function + + - - Choose how fast you want to turn the light on and off - - + + Use this parameter to set the time after which you want the switch to automatically turn off once it has been turned on. The number entered as value corresponds to the number of minutes + + + Use this parameter to enable or disable the auto turn-off timer function + + + + + Use this parameter to set the time after which you want the switch to automatically turn on once it has been turned off. The number entered as value corresponds to the number of minutes + + + Choose which physical and Z-Wave triggers should prompt the dimmer to send a status change report to associated devices. + + + + + + + + + + + + + + + + + + + Set the on off status for switch after power failure + + + + + + Adjust the physical ramp rate for your dimmer (fade-in / fade-out effect for on / off operation). Values correspond to the number of seconds it take for the dimmer to reach full brightness + + + Set the minimum brightness level (in %) for your dimmer. + + + Set the maximum brightness level (in %) for your dimmer. Note if set to 0 parameter is disabled. + + + Choose if dimmer turns to full or custom brightness with double tap of upper paddle. + + + + + Enable or disable the double tap function and assign brightness level to single tap. + + + + + + Enable or disable scene control functionality for quick double tap triggers. + + + + + Enable or disable local control functionality. + + + + + + Set the time it takes to get from 0% to 100% brightness when pressing and holding the paddle (physical dimming). The number entered as value corresponds to the number of seconds. + + + Choose if you want to set the Z-Wave ramp rate independently of the physical ramp rate (using an appropriate command in your hub) or if you want them to match. + + + + + Set the custom brightness level (instead of the last set brightness level) you want the dimmer to come on to when you single tap the upper paddle. 0 is last brightness. + + + Choose the type of 3-way switch you want to use with this dimmer in a 3-way set-up. Changing this setting can allow you to control brightness and dim the light from both 3-way locations. See Zooz help for detailed behavior description. + + + + + + Choose how you'd like the dimmer to report when paddles are tapped and held and physical / Z-Wave control is enabled or disabled. + +