You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
i wanna know the state of a specific pin on my ramps 1.4 .
i'm using mega2560 .
but the "M43" doesnt work . when i execute this gcode in repetier , nothing changes and i am not able to see any result.
what is the problem ? can anyone figure it out ?
what kinda parameters should i give to this gcode in order to find out the state -being high or low- of a pin?
The text was updated successfully, but these errors were encountered:
i wanna know the state of a specific pin on my ramps 1.4 .
i'm using mega2560 .
but the "M43" doesnt work . when i execute this gcode in repetier , nothing changes and i am not able to see any result.
what is the problem ? can anyone figure it out ?
what kinda parameters should i give to this gcode in order to find out the state -being high or low- of a pin?
The text was updated successfully, but these errors were encountered: