config.txt

# For more options and information see
# http://rpf.io/configtxt
# Some settings may impact device functionality. See link above for details

# configuration file for iNap Malinka
# 17 July 2022

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

#uncomment to overclock the arm. 700 MHz is the default.
arm_freq=800

#enabling two aux spi devices
dtoverlay=spi1-2cs

#custom image output
hdmi_force_hotplug=1
hdmi_group=2
hdmi_mode=87
hdmi_cvt=480 320 60 1 0 0 0

# Enable audio (loads snd_bcm2835)
gpio=12,13=a0
dtparam=audio=on
audio_pwm_mode=2
dtoverlay=audremap,pins_12_13

#enable or disable, whichever one sounds better for you
disable_audio_dither=1
#enable_audio_dither=1

#enable FT6236
force_eeprom_read=0
dtparam=i2c1=on
dtparam=i2c_arm=on
dtoverlay=malinkats,touch-swapxy,touch-invx

#disable ACT LED
#dtparam=act_led_trigger=none
#dtparam=act_led_activelow=off
#(apparently doesnt work for pi zero 2w)

[all]
gpu_mem_256=128
gpu_mem_512=256
gpu_mem_1024=256
overscan_scale=1