You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Dev branch (edge add-on) now supports both EmberZNet v7 and v8 (zigbee-herdsman 0.51+). It introduces a lot of changes (which have been applied to v7 as well).
We need some feedback from dev testers! 😉
Please do not report known issues, unless they behave differently, or have been fixed with the new dev branch.
Make sure to specify which version you are testing the dev branch with (v7 or v8).
For v8, you can try one of these firmware. Please note these are preliminary, and remain vastly untested on most adapters at the moment. And also, flashers that don't support v8 yet, will likely not allow you to revert back to v7 after flashing v8 unless you enter the bootloader manually. You can try https://github.com/Nerivec/ember-zli which uses the latest zigbee-herdsman under the hood (please report any issue with this new tool in the repository directly, not here).
Things you will undoubtedly notice:
[v7-v8] Driver-level error/status codes have changed (slightly or completely depending on the place) due to a complete revamp of the EmberZNet firmware.
[v7-v8] Startup sequence no longer assigns some firmware values that were causing troubles due to changes in recent EmberZNet versions. As a result, the startup sequence will look quite a bit shorter in the logs.
[v7-v8] Some logging has been removed/altered to remove sensitive information from log files.
[v8] Support for Silabs chips series 0 and 1 has been removed in new firmware. If you have an older adapter that uses one of these two series, you will not see a v8 firmware for it, and will have to remain to v7, or get a newer model adapter.
Note: MG24-based adapters are still not widely available, but from all appearances, they do offer a nice upgrade from previous models, so you may want to look into these if you find yourself in that situation.
Known issues with v8 firmware:
LQI values are broken in devices list/page (ok in network map). The firmware appears to not be reporting the values properly. - Under investigation.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Dev branch (edge add-on) now supports both EmberZNet v7 and v8 (zigbee-herdsman 0.51+). It introduces a lot of changes (which have been applied to v7 as well).
We need some feedback from dev testers! 😉
Please do not report known issues, unless they behave differently, or have been fixed with the new dev branch.
Make sure to specify which version you are testing the dev branch with (v7 or v8).
For v8, you can try one of these firmware. Please note these are preliminary, and remain vastly untested on most adapters at the moment. And also, flashers that don't support v8 yet, will likely not allow you to revert back to v7 after flashing v8 unless you enter the bootloader manually. You can try https://github.com/Nerivec/ember-zli which uses the latest zigbee-herdsman under the hood (please report any issue with this new tool in the repository directly, not here).
Things you will undoubtedly notice:
Known issues with v8 firmware:
Beta Was this translation helpful? Give feedback.
All reactions