Aqara Temperature and Humidity - WSDCGQ12LM - Reporting Frequency

[maptz]

Hi,

I've got a pair of Aqara WSDCGQ12LM devices. I had it setup so that it was reporting temperature and pressure every minute, but I had a power cut and now I've had to reboot the Zigbee2mqtt system.

For some reason, now the reporting is rather random from each device (around every 5 minutes). I can't seem to update the Reporting frequency in Zigbee2MQTT. It fails with

Request 'zigbee2mqtt/bridge/request/device/configure_reporting' failed with error: 'Bind 0x54ef441000a56f4b/1 msTemperatureMeasurement from '0x6c5cb1fffefc7f61/1' failed ({"address":39334,"clusterId":32801,"sequence":31} after 10000ms)'

I'm sure I successfully set this once, but I don't seem to be able to repeat it.

Can anyone tell me how to set the reporting frequency of the device?

[francisp2]

It is a battery device, so it needs to be awake where changing settings. Press the button just before you change the settings.

[maptz]

Amazing @francisp2. You're totally correct. This worked a treat.

For the sake of any future googling, here's what worked for me:

To set the Aqara temperature modules to report more frequently, you must go to the Reporting page in Zigbee2MQTT

• Select Endpoint 1
• Set Cluster to Temperature
• Set Attribute to MeasuredValue
• Set Min rep interval to 60
• Set Max rep interval to 3600
• Set Min rep change 0

Now. Very important You must press the button on the module itself just before pressing apply on the web interface.