We read every piece of feedback, and take your input very seriously.
To see all available qualifiers, see our documentation.
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Have printed two G2E SB to be sure but during unload filament gets partially stuck right at the very end and needs a hard tug to come out completely.
I believe this is just after the gear. My filament on unload is a bit fatter at the tip.
Can't figure out why (I did the 2mm drill bit)
Maybe my unload macro is not optimal.
Can you share your unload macro for me to test please.
The text was updated successfully, but these errors were encountered:
No branches or pull requests
Have printed two G2E SB to be sure but during unload filament gets partially stuck right at the very end and needs a hard tug to come out completely.
I believe this is just after the gear. My filament on unload is a bit fatter at the tip.
Can't figure out why (I did the 2mm drill bit)
Maybe my unload macro is not optimal.
Can you share your unload macro for me to test please.
The text was updated successfully, but these errors were encountered: