Skip to content

Latest commit

 

History

History
26 lines (22 loc) · 6.92 KB

circle.md

File metadata and controls

26 lines (22 loc) · 6.92 KB
Raw

<Circle /> Component API

Props

Prop Type Default Note
center LatLng (Required) The coordinate of the center of the circle
radius Number (Required) The radius of the circle to be drawn (in meters)
strokeWidth Number 1 The stroke width to use for the path.
strokeColor String #000, rgba(r,g,b,0.5) The stroke color to use for the path.
fillColor String #000, rgba(r,g,b,0.5) The fill color to use for the path.
zIndex Number 0 The order in which this tile overlay is drawn with respect to other overlays. An overlay with a larger z-index is drawn over overlays with smaller z-indices. The order of overlays with the same z-index is arbitrary. The default zIndex is 0. (Android Only)
lineCap String round The line cap style to apply to the open ends of the path. Other values : butt, square
lineJoin String The line join style to apply to corners of the path. possible value: miter, round, bevel
miterLimit Number The limiting value that helps avoid spikes at junctions between connected line segments. The miter limit helps you avoid spikes in paths that use the miter lineJoin style. If the ratio of the miter length—that is, the diagonal length of the miter join—to the line thickness exceeds the miter limit, the joint is converted to a bevel join. The default miter limit is 10, which results in the conversion of miters whose angle at the joint is less than 11 degrees.
lineDashPhase Number 0 (iOS only) The offset (in points) at which to start drawing the dash pattern. Use this property to start drawing a dashed line partway through a segment or gap. For example, a phase value of 6 for the patter 5-2-3-2 would cause drawing to begin in the middle of the first gap.
lineDashPattern Array<Number> null (iOS only) An array of numbers specifying the dash pattern to use for the path. The array contains one or more numbers that indicate the lengths (measured in points) of the line segments and gaps in the pattern. The values in the array alternate, starting with the first line segment length, followed by the first gap length, followed by the second line segment length, and so on.

Types

type LatLng {
  latitude: Number,
  longitude: Number,
}